Extreme Networks Summit WM3000 Series Reference Manual page 80

Controller Information
Protocol
Password
NOTE
In addition to the Protocols listed, on the Summit WM3700 users can also auto-update using USB or Compact
Flash. On the Summit WM3600 users can also auto-update using USB.
3 Refer to the Redundancy Configuration field to enable and define the configuration for automatic
cluster file updates.
Enable
IP Address
User ID
File Name
(With Path)
Protocol
Password
4 Refer to the Firmware field to enable and define the configuration for automatic firmware updates. If
enabled, the located (updated) controller firmware is used with the controller the next time the
controller boots.
Enable
IP Address
User ID
File Name
(With Path)
Protocol
Password
Version
5 Select the Start Update button to begin the file updates for the enabled controller configuration,
cluster configuration or firmware facilities.
6 Click the Apply button to save the changes to the configuration.
7 Click the Revert button to revert back to the last saved configuration.
80
Protocol
Use the drop-down menu to specify the
FLASH
or resident controller
server. FLASH is the default setting.
Enter the password required to access the server.
Enable
Select the checkbox to allow an automatic cluster file update
when a new (updated) file is detected (upon the boot of the controller) at
the specified IP address.
IP address
Define the of the server where the cluster files reside. If a new
version is detected when the controller is booted it will be uploaded to
the controller and used upon the next boot of the controller.
User ID
Enter the required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the cluster files
on the server. This path must be accurate to ensure the most recent file
is retrieved.
Protocol
Use the drop-down menu to specify the
FLASH
or resident controller
server. FLASH is the default setting.
Enter the password required to access the server.
Enable
Select the checkbox to allow an automatic firmware update when
a new (updated) version is detected (upon the boot of the controller) at
the specified IP address.
Define the IP address of the server where the firmware files reside. If a
new version is detected when the controller is booted it will be uploaded
to the controller and used upon the next boot of the controller.
User ID
Enter the required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the firmware
files on the server. This path must be accurate to ensure the file is
retrieved.
Protocol
Use the drop-down menu to specify the
FLASH
or resident controller
server. FLASH is the default setting.
Enter the password required to access the server.
Provide the target firmware version to ensure the controller is upgrading
to the intended baseline.
FTP, TFTP, HTTP, SFTP
medium used for the file update from the
FTP, TFTP, HTTP, SFTP
medium used for the file update from the
FTP, TFTP, HTTP, SFTP
medium used for the file update from the
Summit WM3000 Series Controller System Reference Guide