Configuring Ekahau Parameters - Extreme Networks Summit WM3000 Series Reference Manual

Controller Services
10 Click the Apply button to save the Locate Interval value.
11 Click the Revert button to cancel any changes made within Locate Interval value and revert back to
the last saved configuration.
If the onboard SOLE engine is enabled to locate Aeroscout tags the following information will be
displayed for each located MU:
MAC
Location:
X Coordinate
Location:
Y Coordinate
Timestamp
Zone
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone Configuration please see
the Summit WM3000 Series Controller CLI Reference Guide.

Configuring Ekahau Parameters

To configure the controller to work with an external Ekahau RTLS engine:
1 Services > RTLS from the main menu tree.
306
Lists the MAC Addresses of all MUs which have been located by the
controller.
Displays the value of the X Coordinate for each located MU. The X
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Displays the value of the Y Coordinate for each located MU. The X
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Displays the last time for each MU that its location was computed by the
controller.
Lists the last known zone for each located MU. Zone configuration can be
defined using the CLI interface only. When no zones are configured, the
controller defaults the entire site to Zone 0.
Summit WM3000 Series Controller System Reference Guide