Extreme Networks Summit WM3000 Series Reference Manual page 314

Controller Security
4 If adding a new Allowed AP, use the Index parameter to assign a numerical index value to this
particular Access Point. The index range is from 1-200. If editing an existing Allowed AP, this is a
read only field and cannot be modified.
5 Refer to the BSS MAC Address field to define the following:
Any MAC Address/
Specific MAC
Address
6 Refer to the ESSID field to configure Access Point ESSID permissions.
Any ESSID/Specific
ESSID
7 Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the controller.
8 Click OK to use the changes to the running configuration and close the dialog.
9 Click Cancel to close the dialog without committing updates to the running configuration.
314
Any MAC Address
Click the
detected on the network as an Allowed AP. This is not necessary if a
specific MAC address is used with this index.
Click the second radio button to enter a specific MAC address as an
Allowed AP. Use this option if (for network security) you want to restrict
the number of MAC Addresses to a single MAC address.
Any ESSID
Click the radio button to allow any ESSID located on the
network as an Allowed AP. This may not be necessary if a specific ESSID
was used with this particular index.
Click the second radio button to enter a specific ESSID as an Allowed
AP. Use this option if (for network security) you want to restrict the
number of device ESSIDs saved for this index to a single Access Point
ESSID.
radio button to allow any MAC address
Summit WM3000 Series Controller System Reference Guide