Configuring The Virtual Interface - Extreme Networks Summit WM3000 Series Reference Manual

Network Setup

Configuring the Virtual Interface

Use the Configuration screen to view and configure the virtual interface details.
1 Select Network > Controller Virtual Interface from the main tree menu.
2 Select the Configuration tab.
The following configuration details display in the table:
Name
VLAN ID
DHCP Enabled
Primary IP Address
Primary Subnet Mask Displays the subnet mask assigned for this interface.
Admin Status
Oper Status
100
Displays the name of the virtual interface.
Displays the VLAN ID associated with the interface.
Displays whether the DHCP client is enabled or not. A green check mark
defines the DHCP client as enabled for the interface. A red X means the
interface is disabled.
Displays the IP address for the virtual interface.
Displays whether the virtual interface is operational and available to the
controller.
Displays whether the selected Controller Virtual Interface is currently (Up)
or not (Down) on the controller.
Summit WM3000 Series Controller System Reference Guide