Defining The Ap Radios Mesh Configuration - Extreme Networks Summit WM3000 Series Reference Manual

Network Setup
6 From the Radio Settings section, select the radio type checkboxes corresponding to the type of AP
radio used. Available radio types are dependant on the AP Type selected above.
7 Enter a numerical value in the Radio Index field for each selected radio.
The Radio Index is a numerical value assigned to the radio as a unique identifier. For example: 1, 2,
or 3. The index is helpful for differentiating radios of similar type and configuration.
8 Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the controller.
9 If clustering is configured and the Cluster GUI feature is enabled the Apply to Cluster feature will be
available. Click the Apply to Cluster button to apply the AP radio settings to all members in the
cluster.
10 Click OK to use the changes to the running configuration and close the dialog.
11 Click Cancel to close the dialog without committing updates to the running configuration.

Defining the AP Radios Mesh Configuration

A separate mesh configuration can be set for each AP radio. Define mesh configurations as required
when dedicating an AP radio as either a base or client bridge within a mesh configuration.
NOTE
For the mesh staging phase, connect the mesh supported APs to the controller via the wired network and configure
the mesh topology using the controller CLI. No configuration activities are required using the AP GUI or CLI
To define the selected AP radio's mesh configuration:
1 Select Network > Access Point Radios from the main menu.
2 Click the Configuration tab.
3 Select a target index from amongst those displayed.
4 Select the AP Mesh button at the bottom of the Configuration screen.
188
Summit WM3000 Series Controller System Reference Guide