Extreme Networks Summit WM3000 Series Reference Manual page 303

2 Select the SOLE tab.
3 Check the Locate All Mobile-Units checkbox to locate all MUs known to the controller across all
WLANs. This will also disable manual entry of MU MAC addresses in the field below.
This takes effect immediately when the box is checked.
4 Enter a value for the MU Locate Interval in seconds.
The MU Locate Interval determines how often the locationing of MUs is updated. The valid range for
this is between 5 to 3600 seconds.
5 Click the Apply button to save the MU Locate Interval value.
6 Click the Revert button to cancel any changes made within MU Locate Interval value and revert back
to the last saved configuration.
NOTE
AP coordinates can only be configured in the Command Line Interface. For more information on configuring AP
coordinates please consult the Summit WM3000 Series Controller CLI Reference Guide.
7 The MU MAC table allows you to manually add or remove MAC Addresses which can be located by
the SOLE engine. This supports a maximum of 512 MUs. This table is disabled when the Locate All
MUs checkbox is selected.
a To add MUs to the MU MAC table click the Add button to open a dialogue box allowing you to
add a MAC Address to the MU MAC table allowing it to be located by the controller's SOLE
engine.
Summit WM3000 Series Controller System Reference Guide
303