Extreme Networks Summit WM3000 Series Reference Manual page 249

3 Refer to the Interfaces field for the names of the interfaces available to route information between the
DHCP Server and DHCP clients. If this information is insufficient, consider creating a new IP pool or
edit an existing pool.
4 Refer to the Gateway Information field for DHCP Server and Gateway Interface IP addresses. Ensure
these address are not in conflict with the addresses used to route data between the DHCP Server and
client.
NOTE
The gateway address should not be set to a VLAN interface used by the controller.
5 Click the Edit button to modify the properties displayed on an existing DHCP pool. Refer to step 7
for the information that can be modified for the DHCP relay.
6 To delete an existing DHCP pool from the list of those available to the controller, highlight the pool
from within the Network Pool field and click the Delete button.
NOTE
The interface VLAN and gateway interface should have their IP addresses set. The interface VLAN and gateway
interface should not have DHCP client or DHCP Server enabled. DHCP packets cannot be relayed to an internal
DHCP Server. The interface VLAN and gateway interface cannot be the same.
7 Click the Add button to create a new DHCP pool.
Summit WM3000 Series Controller System Reference Guide
249