Extreme Networks Summit WM3000 Series Reference Manual page 146

Network Setup
Last 30s
Last Hr
Index
ESSID
Description
VLAN
MUs
Throughput Mbps
Avg BPS
% Non-UNI
Retries
4 Click on the Show Filtering Options link to set filtering parameters to filter information displayed on
the screen. Once the Show Filtering Options link is selected, the Filter Option Zone which allows the
selection of filtering parameters is displayed. Up to two parameters may be selected.
Within the Filter Option Zone the following options are presented:
And / Or - Use the And/Or drop down list to expand the selection criteria. Up to two selection
●
criteria are supported.
Filter Entire Table - Click Filter Entire Table to apply the filtering criteria on the information being
●
displayed on the screen.
Turn Off Filtering - Click Turn Off Filtering to turn off filtering and display all information. Use this
●
button and the Filter Entire Table button to refresh screen contents after making changes to the
filtering criteria.
When filtering is disabled, a message is displayed at the bottom of the screen. Similarly, when
filtering is enabled, the filtering criteria is displayed at the same place on the screen.
5 To view WLAN statistics in greater detail, select a WLAN and click the Statistics button. For more
information, see
NOTE
When using mesh enabled WLAN statistics, no statistics are shown. This is because WLAN statistics are
generated by mobile unit traffic for that particular WLAN. In a mesh configuration, there are typically no mobile
units associated and therefore no statistical information to display.
6 To view WLAN statistics in a graphical format, select a WLAN and click the Graph button. For more
information, see
146
Click the Last 30s radio button to display statistics for the WLAN over
the last 30 seconds. This option is helpful when troubleshooting issues as
they actually occur.
Click the Last Hr radio button to displays statistics for the WLAN over the
last 1 hour. This metric is helpful in baselining events over a one hour
interval.
The Idx (or index) is a numerical identifier used to differentiate the
WLAN from other WLANs that may have similar characteristics.
Service Set ID
The SSID is the
The Descr item contains a brief description of the WLAN. Use the
description (along with the index) to differentiate the WLAN from others
with similar attributes.
The VLAN parameter displays the name of the VLAN the WLAN is
associated with.
Lists the number of MUs associated with the WLAN.
Throughput Mbps is the average throughput in Mbps on the selected
WLAN. The Rx value is the average throughput in Mbps for packets
received on the selected WLAN. The Tx value is the average throughput
for packets sent on the selected WLAN.
Displays the average bit speed in Mbps for the selected WLAN. This
includes all packets sent and received.
Displays the percentage of the total packets for the selected WLAN that
are non-unicast packets. Non-unicast packets include broadcast and
multicast packets.
Displays the average number of retries for all MUs associated with the
selected WLAN.
"Viewing WLAN Statistics in Detail" on page
"Viewing WLAN Statistics in a Graphical Format" on page
(SSID) for the selected WLAN.
147.
149.
Summit WM3000 Series Controller System Reference Guide