Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Extreme Networks ExtremeCloud E3125
Summary of Contents for Extreme Networks ExtremeCloud E3125
- Page 1 ExtremeCloud™ IQ Controller E3125 Installation Guide 9037856-00 Rev AA July 2023...
- Page 2 Extreme Networks, Inc. reserves the right to make changes in specifications and other information contained in this document and its website without prior notice. The reader should in all cases consult representatives of Extreme Networks to determine whether any such changes have been made.
-
Page 3: Table Of Contents
Table of Contents Preface.............................. 5 Text Conventions....................................5 Documentation and Training..............................6 Help and Support....................................7 Subscribe to Product Announcements........................7 Send Feedback..................................... 8 Overview............................9 E3125 Control Panel....................................9 E3125 Front Panel Layout..............................9 E3125 Front Control Panel..............................10 E3125 Back Panel Layout..............................12 System Status LED................................... 12 Power Supply Unit LED................................ - Page 4 Table of Contents Index..............................34 ExtremeCloud™ IQ Controller E3125...
-
Page 5: Preface
Preface Read the following topics to learn about: • The meanings of text formats used in this document. • Where you can find additional information and help. • How to reach us with questions and comments. Text Conventions Unless otherwise noted, information in this document applies to all supported environments for the products in question. -
Page 6: Documentation And Training
When a backslash separates two lines of a command input, enter the entire command at the prompt without the backslash. Documentation and Training Find Extreme Networks product information at the following locations: Current Product Documentation Release Notes ExtremeCloud™ IQ Controller E3125... -
Page 7: Help And Support
Extreme Optics Compatibility Other resources such as white papers, data sheets, and case studies Extreme Networks offers product training courses, both online and in person, as well as specialized certifications. For details, visit www.extremenetworks.com/education/. Help and Support If you require assistance, contact Extreme Networks using one of the following... -
Page 8: Send Feedback
You can modify your product selections or unsubscribe at any time. Send Feedback The Information Development team at Extreme Networks has made every effort to ensure that this document is accurate, complete, and easy to use. We strive to improve our documentation to help you in your work, so we want to hear from you. -
Page 9: Overview
Overview E3125 Control Panel on page 9 System Status LED on page 12 Power Supply Unit LED on page 14 Specifications on page 15 Supported Accessories on page 15 The ExtremeCloud IQ Controller E3125 is a wireless LAN controller that helps you manage your Extreme access points. -
Page 10: E3125 Front Control Panel
E3125 Front Control Panel Overview Figure 1: View of E3125 Front Panel Layout Table 4: E3125 front panel features Callout Description Hard disk drive bays. Front video connector. Use the video connector on the back panel if you do not want to remove the faceplate. USB 2.0 or 3.0 ports. - Page 11 Overview E3125 Front Control Panel Figure 2: E3125 front control panel view Table 5: Control panel features Callout Description Comment The System ID button with Push to turn on the identification LED. integrated LED. The Nonmaskable Interrupt (NMI) Push to do a forced system reset. button.
-
Page 12: E3125 Back Panel Layout
E3125 Back Panel Layout Overview E3125 Back Panel Layout The back panel has connectors that can be easier to access than the front panel. You use some of these ports during installation. Figure 3: E3125 back panel layout view Table 6: E3125 back panel layout features Callout Description Power supply module #1... - Page 13 Overview System Status LED Figure 4: System status LED location Table 7: System status LED Callout Description System status LED Table 8: System status LED patterns LED pattern System status Description Solid green Normal System is functioning without any errors. 1 Hz blinking green Issues with the system •...
-
Page 14: Power Supply Unit Led
Power Supply Unit LED Overview Table 8: System status LED patterns (continued) LED pattern System status Description • The controller is unable to use all of the installed memory. • The battery has failed. 1 Hz blinking amber Fatal or unrecoverable An amber LED means there system hardware failure has been a fatal error in... -
Page 15: Specifications
Overview Specifications Specifications Use the following information when you plan your installation. Table 10: Physical specifications Case dimensions • Length: 438mm (17.25 in.) including the rack mounting flanges or ears. • Width: 750mm (29.5 in.) • Height: 43.9mm (1.73 in.) not including mounting bracket Table 11: Environmental specifications Operating temperature... -
Page 16: Hardware Installation
Hardware Installation Installation Workflow on page 16 Verify the Box Contents on page 17 Power Supply Options on page 18 Connect a Power Source on page 18 Install the Power Supply Unit on page 20 Remove the Power Supply Unit on page 21 Remove the Faceplate on page 22... -
Page 17: Verify The Box Contents
One AC power cord bracket and retention strap kit • One rail mounting kit • One rail kit installation instruction sheet 2. Inspect the controller for any physical damage. Contact Extreme Networks Support Portal if there is any damage. ExtremeCloud™ IQ Controller E3125... -
Page 18: Power Supply Options
Power Supply Options Hardware Installation Power Supply Options You can install, remove, or replace a power supply on the ExtremeCloud IQ Controller E3125. For information on installing a power supply, see Connect a Power Source page 18. The controller ships with one installed power supply. But you can purchase additional redundant power supplies separately. - Page 19 Hardware Installation Connect a Power Source Figure 5: Attach the power cord to the controller Procedure 1. Attach the power cord to the power supply module: a. Insert the locking tab end of the retention strap into the receiver hole of the power supply unit.
-
Page 20: Install The Power Supply Unit
Install the Power Supply Unit Hardware Installation Install the Power Supply Unit About This Task The controller ships with one power supply unit. You can replace the existing power supply unit if needed or add a second unit as a backup. Note The controller requires one power supply to operate normally. -
Page 21: Remove The Power Supply Unit
Hardware Installation Remove the Power Supply Unit Procedure 1. Perform of the following tasks depending upon if you are installing a redundant power supply unit or replacing the existing unit: • Install a redundant supply unit: Remove the redundant power supply plate. Grasp the center hole and pull the plate out. -
Page 22: Remove The Faceplate
Remove the Faceplate Hardware Installation Figure 7: View of rear power supply unit Table 16: Power supply unit hardware Callout Description AC power supply unit Handle Power connector Spring loaded tab Procedure 1. Disconnect the power cord from the wall outlet. 2. - Page 23 Hardware Installation Remove the Faceplate About This Task Remove the front faceplate if you need to access the front ports. The front video connector and USB ports are also available on the rear of the controller. Figure 8: Faceplate removal Table 17: Faceplate components Callout Description...
-
Page 24: Initial Network Connection And Configuration
Configure the E3125 from the console port if you have physical access to the controller. Configuration is asynchronous, but you can see the boot up process. Refer to the ExtremeCloud IQ User Guide on the Extreme Networks Documentation Site for more information. - Page 25 Configure the Management Interface from the Console Initial Network Connection and Configuration Port Procedure 1. Connect laptop serial port to the E3125 console port. If the laptop does not support RS232 interface, then obtain a USB to RS232 converter cable, which then connects to the RJ45- DB9F cable. 2.
-
Page 26: Configure The Management Interface From The Management Port
5. Complete the installation to configure the E3125 controller for new deployments. 6. Disconnect your laptop from the controller. 7. Connect the controller management port to the enterprise Ethernet LAN. 8. Log on to Extreme Networks. Note The system is now visible to the enterprise network. Refer to the... - Page 27 Initial Network Connection and Configuration Connect the Data Ports Figure 9: E3125 Data ports Table 18: Data port specifications Item Port Specifications Data Port 1 1/10GbE, RJ45 Data Port 2 1/10GbE, RJ45 Data Port 3 10/25/50/100GbE, QSFP28 Data Port 4 10/25/50/100GbE, QSFP28 Note Data ports 3 and 4 provide QSFP28 ports that can support 50Gbps or 100Gbps...
-
Page 28: Connect Cable To A Transceiver
Connect Cable to a Transceiver Initial Network Connection and Configuration 4. Contact Extreme Networks Support If a link is not established. Connect Cable to a Transceiver Before You Begin Install a transceiver on the Data ports 3 and 4 of the controller. - Page 29 Initial Network Connection and Configuration Install a Transceiver or an Adapter Figure 10: Data ports 3 and 4 on the back panel of the ExtremeCloud IQ Controller E3125 Table 19: Data Ports 3 and 4 specifications Callout Port Port 3 (Data Port 3) 10/25/50/100GbE, QSFP28 Port 4 (Data Port 4) 10/25/50/100GbE, QSFP28 Procedure 1.
-
Page 30: Regulatory And Compliance Information
Regulatory and Compliance Information Regulatory Compliance Information on page 30 Federal Communications Commission (FCC) Notice on page 30 Industry Canada, Class A on page 31 Conformitè Europëenne (CE) Notice on page 31 Japan (VCCI) - Voluntary Control Council for Interference Class A ITE on page 31 BSMI EMC Statement - Taiwan on page 31... -
Page 31: Industry Canada, Class A
Regulatory and Compliance Information Industry Canada, Class A Intel Corporation 5200 N.E. Elam Young Parkway Hillsboro, OR 97124-6497 Phone: 1-800-628-8686 Industry Canada, Class A This Class A digital apparatus complies with Canadian ICES-003. This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the interference-causing equipment standard entitled “Digital Apparatus,”... -
Page 32: Supplement To Product Instructions
Supplement to Product Instructions Regulatory and Compliance Information Supplement to Product Instructions Hazardous Substances This product complies with the requirements of Directive 2011/65/EU and its amendments of the European Parliament and of the Council of 8 June 2011 on the ExtremeCloud™... -
Page 33: European Waste Electrical And Electronic Equipment (Weee) Notice
European Waste Electrical and Electronic Equipment Regulatory and Compliance Information (WEEE) Notice restriction of the use of certain hazardous substances in electrical and electronic equipment. European Waste Electrical and Electronic Equipment (WEEE) Notice In accordance with Directive 2012/19/EU of the European Parliament on waste electrical and electronic equipment (WEEE): 1. - Page 34 Index (continued) E3125 specifications physical specifications 15 accessories 15 product specifications 15 announcements 7 FCC Notice, Federal Communications Commission, box contents 16 Regulatory Information 30 feedback 8 front faceplate remove faceplate 22 compliance information 30 control panel back control panel 9, 10, 12 front Control panel 9, 10, 12 hardware installation conventions...
- Page 35 Index Regulatory Statement, BSMI Statement, EMC Statement, BSMI EMC Statement 31 , see technical support support technical support contacting 7 transceiver ports connect a cable to the transceiver 28 connect the transceiver 28 warnings 5...