Extreme Networks Summit WM3000 Series Reference Manual page 446

Controller Management
Monitor
Help Desk Manager
Network
Administrator
System Administrator Select
Web User
Administrator
Super User
6 Select the access modes you want to assign to the user from the options provided in the Access Modes
panel. Select one or more of the following options:
Console
SSH
Telnet
Applet
NOTE
When establishing a connection to the controller using SSH, ensure that traffic can pass on TCP port 22
between the client and the controller.
NOTE
When establishing a connection to the controller using Telnet, ensure that traffic can pass on TCP port 23
between the client and the controller.
NOTE
When establishing a connection to the controller's applet, ensure that traffic can pass on TCP port 80 for HTTP
access and TCP port 443 for HTTPS between the client and the controller.
7 Refer to the Status field for an indication of any problems that may have arisen.
The Status is the current state of the requests made from applet. This field displays error messages if
something goes wrong in the transaction between the applet and the controller.
8 Click on OK to complete the modification of the users privileges.
9 Click Cancel to revert back to the last saved configuration without saving any of your changes.
446
If necessary, modify user permissions without any administrative rights.
The Monitor option provides
Optionally assign this role to someone who typically troubleshoots and
debugs problems reported by the customer. the Help Desk Manager
typically runs troubleshooting utilities (like a sniffer), executes service
commands, views/retrieves logs and reboots the controller.
The Network Administrator
parameters like IP config, VLANs, Layer 2/Layer 3 security, WLANs,
radios and hotspot.
System Administrator
general settings like NTP, boot parameters, licenses, perform image
upgrade, auto install, manager redundancy/clustering and control access.
Web User Administrator
Assign
Web authentication (hotspot).
Select Super User (if necessary) to assign complete administrative rights.
Provides the new user access to the controller using the console (applet)
Provides the new user access to the controller using SSH.
Provides the new user access to the controller using Telnet
Provides the new user access to the controller using the Web UI (applet)
read-only
permissions.
provides configures all wired and wireless
(if necessary) to allow the user to configure
privileges (if necessary) to add users for
Summit WM3000 Series Controller System Reference Guide