Clear Interface Counters - Dell Force10 Z9000 Configuration Manual

Clear interface counters

The counters in the
does not clear the counters captured by any SNMP program.
To clear the counters, use the following command in the EXEC Privilege mode:
Command Syntax
clear counters [interface]
[ vrrp [vrid] | learning-limit ]
When you enter this command, you must confirm that you want FTOS to clear the interface counters for
that interface (Figure
Figure 19-38. Clearing an Interface
FTOS#clear counters gi 0/0
Clear counters on GigabitEthernet 0/0 [confirm]
FTOS#
show interfaces
command are reset by the
Command Mode
EXEC Privilege
19-38).
clear counters
Purpose
Clear the counters used in the show interface commands for all
VRRP groups, VLANs, and physical interfaces or selected ones.
Without an interface specified, the command clears all interface
counters.
(OPTIONAL) Enter the following interface keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
followed by a number from 1 to 255 for TeraScale and ExaScale.
• For the management interface on the RPM, enter the keyword
ManagementEthernet
range is 0-1, and the port range is 0.
• For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
•
For a VLAN, enter the keyword
4094
E-Series ExaScale platforms support 4094 VLANs with FTOS version
Earlier ExaScale supports 2094 VLANS.
8.2.1.0 and later.
( OPTIONAL)
Enter the keyword
groups configured. Enter a number from 1 to 255 as the
( OPTIONAL)
Enter the keyword
address (SA) drop counters when MAC learning limit is configured on the
interface.
command. This command
loopback
port-channel
followed by slot/port information. The slot
sonet
followed by the slot/
vlan
followed by a number from 1 to
vrrp
to clear statistics for all VRRP
vrid.
learning-limit
to clear unknown source
followed by a
Interfaces | 419