Configuring Access Filters On Soft Pvc And Soft Pvp Passive Connections - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Access Filters on Soft PVC and Soft PVP Passive Connections

On Switch-B, create a two-ended soft PVP on the source switch that uses the passive half leg on the
terminating switch.
Switch-B(config-if)# atm soft-vp 10 dest-address
47.0091.8100.0000.0050.e209.8001.4000.0c82.0030.00 1
On Switch-C, display the passive half-leg configuration information of two-ended soft PVP.
Switch-C# show atm vp interface atm 0/0/1 1
Interface: ATM0/0/1, Type: oc3suni
VPI = 1
Status: UP
Time-since-last-status-change: 00:00:07
Connection-type: SoftVP
Cast-type: point-to-point
Passive half leg
Soft vp location: Destination
Remote ATM address: 47.0091.8100.0000.0050.e209.8001.4000.0c82.0030.00
Remote VPI: 10
Soft vp call state: Active
Usage-Parameter-Control (UPC): pass
Wrr weight: 2
Number of OAM-configured connections: 0
OAM-configuration: disabled
OAM-states:
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx Clp0 q full drops:0, Rx Clp1 qthresh drops:0
Rx connection-traffic-table-index: 1
Rx service-category: UBR (Unspecified Bit Rate)
Rx pcr-clp01: 7113539
Rx scr-clp01: none
Rx mcr-clp01: none
Rx
Rx
Tx connection-traffic-table-index: 1
Tx service-category: UBR (Unspecified Bit Rate)
Tx pcr-clp01: 7113539
Tx scr-clp01: none
Tx mcr-clp01: none
Tx
Tx
Configuring Access Filters on Soft PVC and Soft PVP Passive
Connections
The access filters for soft PVC and soft PVP passive connections feature provides protection to the
passive side of a soft PVC or soft PVP connection in two ways:
•
•
ATM Switch Router Software Configuration Guide
7-42
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
cdvt: 1024 (from default for interface)
mbs: none
cdvt: none
mbs: none
prevents unauthorized access to an ATM network by external users.
reserves the required resources for expected connections to switch.
Chapter 7 Configuring Virtual Connections
OL-7396-01