Cisco Catalyst 8540 MSR Configuration Manual page 556

Configuring CES T1/E1 Interfaces
Command
Switch(config-if)# ces pvc circuit-id
dest-address atm-address [[vpi vpi] vci vci]
[retry-interval [first retry-interval]
[maximum retry-interval]] [follow-ifstate]
Step 13 Switch(config-if)# ces pvc circuit-id
follow-ifstate
Step 14 Switch(config-if)# no shutdown
Examples
The following example shows how to change the default cell delay variation for circuit 0 to 30,000,
using the ces circuit command:
Switch# configure terminal
Switch(config)# interface cbr 3/0/0
Switch(config-if)# shutdown
Switch(config-if)# ces circuit 0 cdv 3000
Switch(config-if)# no shutdown
You must use the shutdown command to shut down the interface before you can modify the circuit. After
Note
modifying the circuit, use the no shutdown command to reenable the interface.
ATM Switch Router Software Configuration Guide
19-6
Chapter 19 Configuring Circuit Emulation Services
Purpose
Configures the destination (active) port for the
circuit and configures a soft PVC, as follows:
Specifies the circuit identification.
•
For unstructured service, use 0.
–
For T1 structured service, use
–
1 through 24.
For E1 structured service, use
–
1 through 31.
Specifies the destination address of the
•
soft PVC.
Specifies the virtual path identifier of the
•
destination PVC.
Specifies the virtual channel identifier of the
•
destination PVC.
Configures retry interval timers for a soft PVC,
•
as follows:
Specifies in milliseconds, the retry interval
–
after the first failed attempt. The default
is 5,000.
– Specifies in seconds, the maximum retry
interval between any two attempts. The
default is 600.
• Configures the source (active) port circuit
status to follow the status of the physical
interface. The default circuit setting ignores the
status of the physical interface.
Configures the destination (passive) port circuit
status for a soft-PVC to follow the status of the
physical interface. The default circuit setting
ignores the status of the physical interface.
Reenables the interface.
OL-7396-01