Cisco Catalyst 8540 MSR Configuration Manual page 670

Configuring Frame Relay to ATM Virtual Connections
!
interface Serial1/0/0:1
description Engineering connections
no ip address
no ip directed-broadcast
encapsulation frame-relay IETF
no arp frame-relay
no snmp trap link-status
frame-relay intf-type nni
atm route-optimization soft-connection interval 30 time-of-day 18:0 5:0
!
Switch# show interfaces serial 3/0/0:1
Serial3/0/0:1 is up, line protocol is up
Hardware is FRPAM-SERIAL
MTU 4096 bytes, BW 1536 Kbit, DLY 0 usec, rely 128/255, load 1/255
Encapsulation FRAME-RELAY IETF, loopback not set, keepalive not set
Last input 00:00:08, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Timeslots(s) Used: 1-24 on T1 1
Frames Received with:
DE set: 0, FECN set :0, BECN set: 0
Frames Tagged :
DE: 0, FECN: 0 BECN: 0
Frames Discarded Due to Alignment Error: 0
Frames Discarded Due to Illegal Length: 0
Frames Received with unknown DLCI: 0
Frames with illegal Header : 0
Transmit Frames with FECN set :0,
Transmit Frames Tagged FECN : 0 BECN : 0
Transmit Frames Discarded due to No buffers : 0
Default Upc Action : tag-drop
Default Bc (in Bits) : 32768
Soft vc route optimization is enabled
Soft vc route optimization interval = 50 minutes
Soft vc route optimization time-of-day range = (20:10 - 23:40)
ATM Switch Router Software Configuration Guide
20-42
Conversations 0/0/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
12963 packets input, 12963 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
12963 input errors, 7638 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
2 carrier transitions
Chapter 20 Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
BECN Set :0
OL-7396-01