Configuring The Atm Address - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide
Hide thumbs Also See for Catalyst 8540 MSR:
Table of Contents

Advertisement

IISP Configuration
Example
The following example shows the ATM routing mode configuration using the more
system:running-config privileged EXEC command:
Switch# more system:running-config
Building configuration...
Current configuration:
!
version 11.2
<information deleted>
!
hostname Switch
!
username dtate
ip rcmd remote-username dplatz
!
atm e164 translation-table
e164 address 1111111 nsap-address 11.111111111111111111111111.112233445566.11
e164 address 2222222 nsap-address 22.222222222222222222222222.112233445566.22
e164 address 3333333 nsap-address 33.333333333333333333333333.112233445566.33
!
atm routing-mode static
atm address 47.0091.8100.0000.0040.0b0a.2b81.0040.0b0a.2b81.00
!
<information deleted>

Configuring the ATM Address

If you are planning to implement only a flat topology network (and have no future plans to migrate to
PNNI hierarchy), you can skip this section and use the preconfigured ATM address assigned by
Cisco Systems.
For information about ATM address considerations, see
Note
To change the active ATM address, create a new address, verify that it exists, and then delete the current
active address. Follow these steps, beginning in global configuration mode:
Command
Step 1
Switch(config)# atm address new-address-template
Step 2
Switch(config)# end
Switch#
Step 3
Switch# show atm addresses
Step 4
Switch# configure terminal
Switch(config)#
Step 5
Switch(config)# no atm address
old-address-template
Example
The following example shows how to add the ATM address prefix 47.0091.8100.5670.000.0ca7.ce01.
Using the ellipses (...) adds the default Media Access Control (MAC) address as the last six bytes.
ATM Switch Router Software Configuration Guide
11-4
Chapter 11
Configuring ATM Routing and PNNI
ATM Addresses, page
11-2.
Purpose
Configures the ATM address for the switch.
Returns to privileged EXEC mode.
Verifies the new address.
Enters configuration mode from the terminal.
Removes the old ATM address from the
switch.
OL-7396-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 8510 msrLightstream 1010

Table of Contents