Cisco Catalyst 8540 MSR Configuration Manual page 466

Configuring SNMP
Command
show snmp
Example
The following example shows the SNMP configuration using the show snmp privileged EXEC
command:
Switch# show snmp
497 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
50 Number of requested variables
249 Number of altered variables
30 Get-request PDUs
162 Get-next PDUs
249 Set-request PDUs
441 SNMP packets output
0 Too big errors (Maximum packet size 1500)
162 No such name errors
0 Bad values errors
0 General errors
441 Response PDUs
0 Trap PDUs
SNMP global trap: enabled
SNMP logging: enabled
Logging to 172.20.52.3.162, 0/10, 0 sent, 0 dropped.
The following example shows the SNMP group configuration using the show snmp group privileged
EXEC command:
Switch# show snmp group
groupname: ILMI
readview :*ilmi
notifyview: <no notifyview specified>
row status: active
groupname: ILMI
readview :*ilmi
notifyview: <no notifyview specified>
row status: active
groupname: comaccess
readview :v1default
notifyview: *tv.FFFFFFFF.FFFFFFFF
row status: active
groupname: comaccess
readview :v1default
notifyview: <no notifyview specified>
row status: active
Switch#
ATM Switch Router Software Configuration Guide
15-24
Purpose
Used to show the status of communications between the SNMP agent and SNMP
manager.
Chapter 15 Configuring ATM Accounting, RMON, and SNMP
security model:v1
writeview: *ilmi
security model:v2c
writeview: *ilmi
security model:v1
writeview: <no writeview specified>
security model:v2c
writeview: <no writeview specified>
OL-7396-01