Cisco Catalyst 8540 MSR Configuration Manual page 848

Configuring VC Bundling with IP and ATM QoS
Command
Step 3 Switch(config-subif)# bundle name
Switch(config-if-atm-bundle)#
Step 4 Switch(config-if-atm-bundle)# protocol {ip-address | ip
ip-address | ipx ipx-address | inarp} [[no] broadcast]
Step 5 Switch(config-if-atm-bundle)# oam-bundle manage
frequency-seconds
Step 6 Switch(config-if-atm-bundle)# pvc-bundle vpi vci interface
atm card/subcard/port vpi vci [upc {tag | drop | pass}] [pd
{on | off | use-cttr}] [rx-cttr rx-row] [tx-cttr tx-row]
[wrr-weight value]
Switch(config-if-atm-member)#
Step 7 Switch(config-if-atm-member)# precedence {other | range} Configures the precedence level associated with the
Step 8 Switch(config-if-atm-member)# bump {implicit | explicit
precedence-level | traffic}
Step 9
Switch(config-if-atm-member)# protect {group | vc}
Step 10
Switch(config-if-atm-member)# exit
Switch(config-if-atm-bundle)#
The following example configures eight PVCs as members of a VC bundle named Connection to
Switch2.
Switch(config)# interface atm 9/0/0.1 multipoint
Switch(config-subif)# description Connection to Switch2
Switch(config-subif)# ip address 3.0.0.1 255.0.0.0
Switch(config-subif)# bundle cisco
Switch(config-if-atm-bundle)# protocol ip inarp
Switch(config-if-atm-bundle)# oam-bundle manage broadcast
Switch(config-if-atm-bundle)# pvc-bundle 2 200 pd on wrr-weight 2 rx-cttr 301 tx-cttr 301 interface atm
0/0/0.1 2 300
Switch(config-if-atm-member)# precedence 3, 5-7
Switch(config-if-atm-member)# pvc-bundle 2 201 pd on wrr-weight 2 rx-cttr 302 tx-cttr 302 interface atm
0/0/0.1 2 301
Switch(config-if-atm-member)# precedence 4
Switch(config-if-atm-member)# pvc-bundle 2 202 pd on wrr-weight 2 rx-cttr 303 tx-cttr 303 interface atm
0/0/0.1 2 302
Switch(config-if-atm-member)# precedence 2
Switch(config-if-atm-member)# pvc-bundle 2 203 pd on interface atm 0/0/0.1 2 303
Switch(config-if-atm-member)# exit
Switch(config-if-atm-bundle)#
ATM Switch Router Software Configuration Guide
25-46
Chapter 25 Configuring ATM Router Module Interfaces
Purpose
Creates the VC bundle changes to VC bundle
configuration mode.
Configures the VC bundle protocol.
Enables end-to-end F5 OAM loopback cell
generation and OAM management for all VCs in the
VC bundle.
Configures the VC bundle member and changes to
VC bundle member configuration mode.
VC bundle member.
Configures the bumping rules (switching if a VC
fails) for a specific VC bundle member.
Configures the VC to belong to a protected group or
to be individually protected.
Exits back to VC bundle configuration mode to
configure another PVC in the bundle.
OL-7396-01