Setting Up The Server, Bus, And A Client On A Subinterface; Setting Up A Client On A Subinterface - Cisco Catalyst 8540 MSR Configuration Manual

LANE Configuration Tasks

Setting Up the Server, BUS, and a Client on a Subinterface

To set up the server, BUS, and (optionally) clients for an emulated LAN, perform the following steps,
beginning in global configuration mode:
Command
Step 1 Switch(config)# interface atm 0.subinterface#
[multipoint]
Switch(config-subif)#
Step 2 Switch(config-subif)# lane server-bus {ethernet
| tokenring} elan-name1
Step 3 Switch(config-subif)# lane client {ethernet |
tokenring} [elan-name1]
Step 4 Switch(config-subif)# ip address ip-address mask Provides a protocol address for the client.
If the emulated LAN in Step 2 will have restricted membership, consider carefully whether you want to
specify its name here. You will specify the name in the LECS's database when it is set up. However, if
you link the client to an emulated LAN, and by some mistake it does not match the database entry linking
the client to an emulated LAN, this client will not be allowed to join this or any other emulated LAN.
If you do decide to include the name of the emulated LAN linked to the client in Step 3 and later want
to associate that client with a different emulated LAN, make the change in the configuration server's
database before you make the change for the client on this subinterface.
Each emulated LAN is a separate subnetwork. In Step 4, make sure that the clients of the same emulated
LAN are assigned protocol addresses on the same subnetwork, and that clients of different emulated
LANs are assigned protocol addresses on different subnetworks.
For examples of these commands, see

Setting Up a Client on a Subinterface

On any given router or switch router, you can set up one client for one emulated LAN or multiple clients
for multiple emulated LANs without a server and BUS. You can set up a client for a given emulated LAN
on any routers you select to participate in that emulated LAN. Any router with clients for multiple
emulated LANs can route packets among those emulated LANs.
ATM Switch Router Software Configuration Guide
14-12
Purpose
Specifies the subinterface for the first emulated
LAN on this router.
Enables a LES and a LANE BUS for the first
emulated LAN. (The tokenring option is not
supported on the Catalyst 8540 MSR.)
(Optional.) Enables a LANE client for the first
emulated LAN. (The tokenring option is not
supported on the Catalyst 8540 MSR.)
LANE Configuration Examples, page
Chapter 14 Configuring LAN Emulation
14-17.
OL-7396-01