Cisco Catalyst 8540 MSR Configuration Manual page 193

Chapter 7 Configuring Virtual Connections
On Switch-B, create a two-ended soft PVC on the source switch that uses the passive half leg on the
terminating switch.
Switch-B(config)# interface atm 3/0/1
Switch-B(config-if)# atm soft-vc 0 50 dest-address
47.0091.8100.0000.0001.4204.d801.4000.0c85.8000.00 1 60
On Switch-C, display the passive half-leg configuration information of two-ended soft PVC with the
filter set fset1 configured.
Switch-C# show atm vc interface atm 0/0/1 23 1 60
Interface: ATM11/0/0, Type: quad_oc12suni
VPI = 1
Status: UP
Time-since-last-status-change: 1d08h
Connection-type: SoftVC
Cast-type: point-to-point
Passive half leg
Soft vc location: Destination
Remote ATM address: default
Remote VPI: 0
Remote VCI: 50
Access-control: Filter-set - fset1
Soft vc call state: Active
Packet-discard-option: disabled
Usage-Parameter-Control (UPC): pass
Wrr weight: 2
Number of OAM-configured connections: 0
OAM-configuration: disabled
OAM-states:
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx Clp0 q full drops:0, Rx Clp1 qthresh drops:0
Rx connection-traffic-table-index: 1
Rx service-category: UBR (Unspecified Bit Rate)
Rx pcr-clp01: 7113539
Rx scr-clp01: none
Rx mcr-clp01: none
Rx
Rx
Tx connection-traffic-table-index: 1
Tx service-category: UBR (Unspecified Bit Rate)
Tx pcr-clp01: 7113539
Tx scr-clp01: none
Tx mcr-clp01: none
Tx
Tx
Switch-C#
OL-7396-01
VCI = 60
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
cdvt: 1024 (from default for interface)
mbs: none
cdvt: none
mbs: none
Configuring Access Filters on Soft PVC and Soft PVP Passive Connections
ATM Switch Router Software Configuration Guide
7-45