Deleting A Previously Established Circuit - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 19 Configuring Circuit Emulation Services
Cell-Rate: 4107, Bit-Rate 1544000
cas OFF, cell_header 0x100 (vci = 16)
cdv 2000 usecs, Measured cdv 350 usecs
ErrTolerance 8, idleCircuitdetect OFF, onHookIdleCode 0x0
state: VcAlarm, maxQueueDepth
Partial Fill:
HardPVC
src: CBR3/0/0 vpi 0, vci 16
Dst: ATM0/1/3 vpi 0, vci 100
The output from this command verifies the following configuration information:
•
•
•

Deleting a Previously Established Circuit

This section describes how to delete a previously established circuit.
To delete a previously established circuit, follow these steps, beginning in privileged EXEC mode:
Command
Step 1 Switch# show ces circuit
Step 2 Switch# configure terminal
Switch(config)#
Step 3
Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Step 4 Switch(config-if)# no ces circuit circuit-id
Step 5 Switch(config-if)# exit
Switch(config)#
Step 6 Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Step 7 Switch(config-if)# no ces circuit circuit-id
Example
The following example shows how to delete a previously established circuit:
CESwitch# show ces circuit
Interface
CBR3/0/0
CBR3/0/3
CESwitch# configure terminal
CESwitch(config)# interface cbr 3/0/0
CESwitch(config-if)# no ces circuit 0
CESwitch(config-if)# exit
CESwitch(config)# interface cbr 3/0/3
OL-7396-01
47, Structured Data Transfer 0
The circuit named CBR-PVC-A is UP.
The clock source is network-derived.
The AAL1 clocking method is synchronous.
Circuit Circuit-Type X-interface X-vpi X-vci Status
0 HardPVC
0 HardPVC
879, startDequeueDepth
Purpose
Shows the configuration information for the
circuit.
Enters global configuration mode from the
terminal.
Selects the physical interface where the circuit is
to be deleted.
Deletes the CES circuit.
Exits interface configuration mode and returns to
global configuration mode.
Selects the other physical interface where the
circuit is to be deleted.
Deletes the other end of CES circuit.
ATM0/0 0 100
ATM0/0 0 101
ATM Switch Router Software Configuration Guide
Deleting a Previously Established Circuit
491
UP
UP
19-55