Phase 2—Configuring The Source (Active) Side Of The Unstructured Switched Vc - Cisco Catalyst 8540 MSR Configuration Manual

Configuring T1/E1 CES SVCs
CESwitch(config-if)# ces dsx1 clock source network-derived
CESwitch(config-if)# ces circuit 0 circuit-name CBR-SVC-B
CESwitch(config-if)# no shutdown
Note If you do not specify the circuit name and logical name parameters in the command line, the system
automatically assigns a unique default name in the form CBRx/y/z:# for the circuit being configured. For
example, the default name for this particular circuit is CBR0/0/1:0.
Phase 2—Configuring the Source (Active) Side of the Unstructured Switched VC
To configure the source (active) side of an unstructured switched VC destination port, follow these steps,
beginning in privileged EXEC mode:
Command
Step 1 Switch# show ces status
Step 2 Switch# show ces address
Step 3 Switch# configure terminal
Switch(config)#
Step 4 Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Step 5 Switch(config-if)# shutdown
Step 6 Switch(config-if)# ces aal1 service unstructured Configures the CES interface AAL1 service type.
Step 7
Switch(config-if)# ces aal1 clock {adaptive | srts
| synchronous}
Step 8
Switch(config-if)# ces circuit 0 [cas] [cdv
max-req] [circuit-name name] [partial-fill
number] [shutdown] [timeslots number]
[on-hook-detect pattern]
Step 9
Switch(config-if)# ces svc circuit-id dest-address
atm-address [hold-priority priority]
[follow-if-state] [retry-interval [first
retry-interval] [maximum retry-interval]]
Step 10
Switch(config-if)# no shutdown
ATM Switch Router Software Configuration Guide
19-46
Chapter 19 Configuring Circuit Emulation Services
Purpose
Displays information about the current CBR
interfaces.
Use this command to choose the source CBR
port.
Shows the CES address and VPI/VCI for the
destination end of the circuit.
At the privileged EXEC prompt, enters global
configuration mode.
Selects the physical interface to be configured.
Disables the interface.
(Optional) Configures the AAL1 clock mode.
Configures the following CES connection
attributes for the circuit:
Circuit id number 0 and circuit name.
Enables channel-associated signalling for
structured service only. The default is no cas.
Enables the peak-to-peak cell delay variation
(CDV) requirement. The default is 2000
milliseconds.
Configures the switched VC to the CBR
interface.
Reenables the interface.
OL-7396-01