VPLS Configuration over MPLS-TP
Command or Action
Step 7
exit
Example:
Router(config-if)# exit
Step 8
exit
Example:
Router(config)# exit
Step 9
show mpls tp link-numbers
Example:
Router# show mpls tp link-numbers
Configuring an Access Interface
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type/num
4. no ip address
5. negotiation auto
6. service instance id service-type
7. encapsulation dot1q vlan-id second-dot1q {any | vlan-id | vlan-id-vlan-id[,vlan-id-vlan-id]}
8. bridge-domain vlan-id [access | dot1q [tag] | dot1q-tunnel] [broadcast] [ignore-bpdu-pid]
[pvst-tlvCE-vlan] [increment] [lan-fcs] [split-horizon]
9. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Purpose
Multiple tunnels and LSPs can refer to the MPLS-TP link to indicate
they are traversing that interface. You can move the MPLS-TP link
from one interface to another without reconfiguring all the MPLS-TP
tunnels and LSPs that refer to the link.
Link numbers a must be unique on the router or node.
Exits interface configuration mode.
Exits global configuration mode.
Displays the configured links.
Purpose
Enables privileged EXEC mode.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Configuring MPLS-TP Links and Physical Interfaces
• Enter your password if prompted.
117