Displaying The Generated Rmon Events; Configuring An Rmon Alarm; Displaying The Generated Rmon Alarms - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 15 Configuring ATM Accounting, RMON, and SNMP

Displaying the Generated RMON Events

To display the generated RMON events, use the following EXEC command:
Command
show rmon events
Example
The following example shows the RMON events generated using the show rmon events EXEC
command:
Switch# show rmon events
Event 1 is active, owned by nms_3
Description is test
Event firing causes trap to community test, last fired 00:00:00

Configuring an RMON Alarm

You can configure RMON alarm generation if any of the configured parameters are met.
Refer to the Configuration Fundamentals Configuration Guide for general SNMP RMON configuration
Note
information.
To configure RMON alarms, use the following command in global configuration mode:
Command
rmon alarm number variable interval {delta |
absolute} rising-threshold value [event-number]
falling-threshold value [event-number]
[owner string]
Example
The following example shows how to configure RMON alarm number 1 to generate an alarm under the
following conditions:
•
•
•
Switch(config)# rmon alarm 1 atmHostInHCCells 500 absolute rising-threshold 10000
falling-threshold 1000 owner "nms 3"

Displaying the Generated RMON Alarms

To display the RMON alarm event, use the following EXEC command:
OL-7396-01
If the MIB atmHostHCCells exceed 500
If each sample, in absolute mode, shows:
Rising threshold exceeding 10,000
–
Falling threshold falling below 1000
–
The RMON alarm number 1 sends the alarm to the owner "nms 3"
Purpose
Displays generated RMON events.
Purpose
Configures the ATM RMON alarm.
ATM Switch Router Software Configuration Guide
Configuring ATM RMON
15-19