Cisco Catalyst 8540 MSR Configuration Manual page 51

Atm switch router software configuration guide
Hide thumbs Also See for Catalyst 8540 MSR:
Table of Contents

Advertisement

Chapter 2
Understanding the User Interface
Table 2-1
Summary of Command Modes (continued)
Command Mode
Interface range
configuration
Subinterface
configuration
Line configuration
Map-list configuration
Map-class configuration
ATM router configuration From global configuration
OL-7396-01
Access Method
From global configuration
mode, specify a range of
interfaces to configure with an
interface range command.
From interface configuration
mode, specify a subinterface
with an interface command.
From global configuration
mode, specify a line with a
line command.
From global configuration
mode, define a map list with
the map-list command.
From global configuration
mode, configure a map class
with the map-class command.
mode, configure the PNNI
routing protocol with the
atm router pnni command.
Prompt
Switch(config-if)#
Switch(config-subif)#
Switch(config-line)#
Switch(config-map-list)#
Switch(config-map-class)#
Switch(config-atm-router)#
ATM Switch Router Software Configuration Guide
Accessing Each Command Mode
Exit Method
To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
To exit to global
configuration mode, use the
exit command.
To enter map-class
configuration mode, use the
map-class command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
To exit to global
configuration mode, use the
exit command.
To enter map-list
configuration mode, use the
map-list command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode use the end
command or press Ctrl-Z.
2-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 8510 msrLightstream 1010

Table of Contents