Configuring Aggregation Token - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 11 Configuring ATM Routing and PNNI
Example
The following example shows how to enable redistribution of static routes:
Switch(config)# atm router pnni
Switch(config-atm-router)# node 1
Switch(config-pnni-node)# redistribute atm-static
Displaying the Redistribution Configuration
To display the node redistribution configuration, use the following privileged EXEC command:
Command
show atm pnni local-node
Example
The following example shows the node redistribution configuration using the show atm pnni local-node
privileged EXEC command:
Switch# show atm pnni local-node
PNNI node 1 is enabled and running

Configuring Aggregation Token

The aggregation token controls the grouping of multiple physical links into logical links. Uplinks to the
same higher level node, or upnode, with the same aggregation token value, are represented at a higher
level as horizontal aggregated links. Resource Availability Information Groups (RAIGs) are computed
according to the aggregation algorithm.
OL-7396-01
Node name: Switch
System address 47.00918100000000400B0A3081.00400B0A3081.00
Node ID 56:160:47.00918100000000400B0A3081.00400B0A3081.00
Peer group ID 56:47.0091.8100.0000.0000.0000.0000
Level 56, Priority 0, No. of interfaces 4, No. of neighbors 2
Node Allows Transit Calls
Hello interval 15 sec, inactivity factor 5,
Hello hold-down 10 tenths of sec
Ack-delay 10 tenths of sec, retransmit interval 5 sec,
Resource poll interval 5 sec
PTSE refresh interval 1800 sec, lifetime factor 200 percent,
Min PTSE interval 10 tenths of sec
Auto summarization: on, Supported PNNI versions: newest 1, oldest 1
Default administrative weight mode: uniform
Max admin weight percentage: -1
Next resource poll in 3 seconds
Max PTSEs requested per PTSE request packet: 32
Redistributing static routes: Yes
Purpose
Displays the node redistribution
configuration.
ATM Switch Router Software Configuration Guide
Advanced PNNI Configuration
11-43