Configuring Two-Ended Soft Pvc Connections - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 7 Configuring Virtual Connections

Configuring Two-Ended Soft PVC Connections

To configure a two-ended soft PVC connection, follow these steps:
.
Command
Step 1
Switch-C(config)# atm filter-set name [index
[number]] [permit | deny] [template | time-of-day
{anytime | start-time {end-time}}]
Step 2
Switch-C(config)# interface atm
card/subcard/port
Switch-C(config-if)#
Step 3
Switch-C(config-if)# atm soft-vc dest-vpi
dest-vci passive [pd pd] [upc upc] [rx-cttr index]
[tx-cttr index] [access-control {src-address
atm-address | filter-set name}]
Step 4
Switch-B(config-if)# atm soft-vc source-vpi
source-vci dest-address atm-address dest-vpi
dest-vci [enable | disable] [upc upc] [pd pd]
[rx-cttr index] [tx-cttr index] [retry-interval
[first retry-interval] [maximum retry-interval]]
Step 5 Switch-C(config-if)# end
Step 6
Switch-C# show atm vc interface atm
card/subcard/port vpi vci
The default value for the upc option is pass.
Note
The default value for the pd option is use-cttr.
Note
For VBR-nrt and VBR-rt service categories you must configure the MBS (even if the value is default)
Note
in the ATM connection traffic table row attached to the passive leg.
You can use the debug atm sig-soft (interface) and debug atm rm events commands to get information
Note
on why a passive leg is not used due to traffic parameter mismatches.
OL-7396-01
Configuring Two-Ended Soft PVC and Soft PVP Connections
Purpose
(Optional) Used to configure the access-control
filter-set parameter in on the passive
destination-side of the soft VC.
Selects the interface, on the terminating switch,
being configured.
Configures the passive leg on the terminating
switch interface.
Creates a two-ended soft PVC on the source
switch that uses the passive half leg on the
terminating switch.
Switches to EXEC command mode.
Displays the passive half-leg configuration
information of two-ended soft PVC.
ATM Switch Router Software Configuration Guide
7-39