Chapter 21
Configuring IMA Port Adapter Interfaces
Confirming the Interface Deletion
To confirm the interface deletion from the IMA group, use the following EXEC command:
Command
show ima interface atm card/subcard/port
Example:
The following example shows how to verify that the interface is deleted from the IMA group:
SwitchA# show ima interface atm 0/0/1
ATM0/0/1 is not a part of IMA group
Deleting an IMA Group
To delete an IMA group, use the following global configuration command:
Command
no interface atm card/subcard/imagroup Deletes the IMA group from the T1/E1
When you delete an IMA group, the interfaces remain configured as members of the IMA group. When
Note
you recreate the IMA group, the member interfaces reinitialize automatically.
Example
The following example shows how to delete ATM interface 0/0/ima1 and administratively shut down the
member interfaces:
Switch(config)# no interface atm 0/0/ima1
Confirming the IMA Group Deletion
To confirm the IMA group deletion, perform the following steps in user EXEC mode:
Command
show ima interface [atm card/subcard/imagroup
[detailed]]
Example
The following example shows how to verify that the interface is deleted from the IMA group:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface atm 0/0/2
Switch(config-if)# shut
OL-7396-01
Purpose
Displays IMA group interface configuration
and status.
Purpose
IMA interface.
Purpose
Displays IMA group interface configuration
and status.
End with CNTL/Z.
ATM Switch Router Software Configuration Guide
Configuring IMA Group Functions
21-11