Configuring Traffic Parameters For Point-To-Multipoint Soft-Pvc Connections - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Point-to-Multipoint Soft PVC Connections
The following example shows the point-to-multipoint soft PVC configuration of the Source switch, on
interface ATM 0/0/1 (VPI = 50, VCI = 100):
Source# show atm vc interface atm 0/0/1 50 100
Interface: ATM0/0/1, Type: oc3suni
VPI = 50
Status: NOT CONNECTED
Time-since-last-status-change: 04:45:52
Connection-type: SoftVC
Cast-type: point-to-multipoint-root
Hold-priority: none
Soft vc location: Source
Remote ATM address: default
Remote VPI: 0
Remote VCI: 0
Soft vc call state: Inactive
Packet-discard-option: disabled
Usage-Parameter-Control (UPC): pass
Wrr weight: 2
Number of OAM-configured connections: 0
OAM-configuration: disabled
OAM-states:
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx Clp0 q full drops:0, Rx Clp1 qthresh drops:0
Rx connection-traffic-table-index: 1
Rx service-category: UBR (Unspecified Bit Rate)
Rx pcr-clp01: 7113539
Rx scr-clp01: none
Rx mcr-clp01: none
Rx
Rx
Tx connection-traffic-table-index: 1
Tx service-category: UBR (Unspecified Bit Rate)
Tx pcr-clp01: 7113539
Tx scr-clp01: none
Tx mcr-clp01: none
Tx
Tx

Configuring Traffic Parameters for Point-to-Multipoint Soft-PVC Connections

To configure the traffic parameters for a point-to-multipoint Soft PVC connection, perform the following
steps, beginning in ATM Soft PVC point-to-multipoint configuration mode:
Command
Step 1
Switch(atmsoft-p2mp)# packet-discard {on | off
| use-cttr}
ATM Switch Router Software Configuration Guide
7-68
VCI = 100
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
cdvt: 1024 (from default for interface)
mbs: none
cdvt: none
mbs: none
Chapter 7 Configuring Virtual Connections
Purpose
Configures the (early) packet discard option on a
point-to-multipoint soft PVC connection.
OL-7396-01