Cisco Catalyst 8540 MSR Configuration Manual page 282

Configuring Physical Interfaces
These commands affect all connections, including those already established.
Note
These commands are not applicable for subinterface level configurations. For other restrictions, refer to
the ATM Switch Router Command Reference publication.
Examples
The following example shows how to configure the interface output threshold CBR discard threshold to
87 percent of maximum size:
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm output-threshold cbr discard 87
The following example shows how to configure the interface output discard threshold for CBR EFCI
threshold to 50 percent of maximum size:
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm output-threshold cbr efci 50
Displaying the Output Threshold Maximum Configuration (Catalyst 8510 MSR and LightStream 1010)
To display the output threshold maximum size configuration, use the following user EXEC command:
Command
show atm interface resource atm
card/subcard/port
Example
The following example shows the interface output threshold maximum size config
installed:
Switch> show atm interface resource atm 3/0/0
Resource Management configuration:
ATM Switch Router Software Configuration Guide
9-20
Output queues:
Max sizes(explicit cfg): 30000
Max sizes(installed): 30208 cbr, 256 vbr-rt, 4096 vbr-nrt, 12032 abr-ubr
Efci threshold: 50% cbr, 25% vbr-rt, 25% vbr-nrt, 25% abr, 25% ubr
Discard threshold: 87% cbr, 87% vbr-rt, 87% vbr-nrt, 87% abr, 87% ubr
Abr-relative-rate threshold: 25% abr
Pacing: disabled 0 Kbps rate configured, 0 Kbps rate installed
Service Categories supported: cbr,vbr-rt,vbr-nrt,abr,ubr
Link Distance: 0 kilometers
Controlled Link sharing:
Max aggregate guaranteed services: none RX,
Max bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Min bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Best effort connection limit: disabled
Max traffic parameters by service (rate in Kbps, tolerance in cell-times):
Peak-cell-rate RX: none cbr, none vbr, none abr, none ubr
Peak-cell-rate TX: none cbr, none vbr, none abr, none ubr
Sustained-cell-rate: none vbr RX, none vbr TX
Minimum-cell-rate RX: none abr, none ubr
Minimum-cell-rate TX: none abr, none ubr
CDVT RX: none cbr, none vbr, none abr, none ubr
Chapter 9
Purpose
Displays the output threshold maximum size
configuration.
cbr, none vbr-rt, none vbr-nrt, none abr-ubr
none TX
0 max connections
Configuring Resource Management
with FC-PCQ
uration
OL-7396-01