Displaying The Iisp Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Configuring IISP Interfaces

Displaying the IISP Configuration

To show the interface IISP configuration, use the following EXEC command:
Command
show atm interface atm card/subcard/port[.vpt#] Shows the interface configuration.
Example
The following example shows the configuration of ATM interface 3/0/0 on the ATM switch router
(SB-1):
Switch(SB-1)# show atm interface atm 3/0/0
Interface:
IF Status:
Auto-config:
IF-Side:
Uni-type:
Max-VPI-bits:
Max-VP:
ConfMaxSvpcVpi: 255
ConfMaxSvccVpi: 255
ConfMinSvccVci: 35
Svc Upc Intent: pass
ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.8000.00
Configured virtual links:
PVCLs SoftVCLs
Logical ports(VP-tunnels):
Input cells:
5 minute input rate:
5 minute output rate:
Input AAL5 pkts: 172421, Output AAL5 pkts: 176993, AAL5 crc errors: 0
ATM Switch Router Software Configuration Guide
6-8
ATM3/0/0
UP
disabled
User
not applicable
8
255
SVCLs TVCLs
3 0 0
264089
Purpose
Port-type: oc3suni
Admin Status: up
AutoCfgState: not applicable
IF-type: IISP
Uni-version: V3.0
Max-VCI-bits: 14
Max-VC: 16383
CurrMaxSvpcVpi: 255
CurrMaxSvccVpi: 255
CurrMinSvccVci: 35
Signalling: Enabled
PVPLs SoftVPLs SVPLs Total-Cfgd Inst-Conns
0 0 0
0
Output cells: 273253
0 bits/sec, 0 cells/sec
0 bits/sec, 0 cells/sec
Chapter 6 Configuring ATM Network Interfaces
0 3 2
OL-7396-01