Displaying Lane Default Addresses - Cisco Catalyst 8540 MSR Configuration Manual

LANE Configuration Tasks
•
•
•
Virtual LANs (VLANs) need to be configured on the LAN edge switches. These VLANs must be
Note
mapped to the appropriate ELANs.
Continue with the following sections to start configuring LANE on your ATM network.

Displaying LANE Default Addresses

To make configuration easier, you should display the LANE default addresses for each router or switch
router that is running any of the LESs or services and write down the displayed addresses on your
worksheet.
To display the default LANE addresses, use the following EXEC command:
Command
show lane default-atm-addresses
Example
The following example displays the default LANE addresses:
Switch# show lane default-atm-addresses
interface ATM13/0/0:
LANE Client:
LANE Server:
LANE Bus:
LANE Config Server: 47.00918100000000E04FACB401.00E04FACB405.00
note: ** is the subinterface number byte in hex
ATM Switch Router Software Configuration Guide
14-6
—ELAN name: eng_elan
—Default ELAN name: eng_elan
—ATM address: 47.00918100000000E04FACB401.00E04FACB403.01
LANE Client:
—Location: ATM_Switch
—Interface/Subinterface: atm 0.1
—Server/BUS name: eng_elan
—IP Address/Subnet mask: 172.16.0.4 255.255.0.0
—Type: Ethernet
LANE Client:
—Location: Switch_1
—Interface/Subinterface: atm 0.1
—Server/BUS name: eng_elan
—Type: Ethernet
LANE Client:
—Location: Router_1
—Interface/Subinterface: atm 3/0.1
—Server/BUS name: eng_elan
—IP Address/Subnet mask: 172.16.0.1 255.255.0.0
—Type: Ethernet
47.00918100000000E04FACB401.00E04FACB402.**
47.00918100000000E04FACB401.00E04FACB403.**
47.00918100000000E04FACB401.00E04FACB404.**
Chapter 14
Purpose
Displays the LANE default addresses for all
ATM interfaces present on the router or
switch router.
Configuring LAN Emulation
OL-7396-01