Configuring Point-To-Multipoint Soft Pvc Connections - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 7 Configuring Virtual Connections
The following show atm addresses command displays the both the active and standby soft VC
redundant address of a single switch configuration with load balancing configured.
Switch# show atm addresses
.
[Information Deleted]
.
Soft VC Redundant Address(es):
47.0091.8100.0000.00a0.f209.b601.3000.0c88.1080.00 ATM0/0/1(A)
47.0091.8100.0000.00a0.f209.b601.3333.3333.3333.00 ATM0/0/1(A)
11.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00 ATM0/0/1 ATM0/0/3 - LB
12.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00
13.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00 ATM0/1/ima0 ATM0/0/0 - LB
.
[Information Deleted]
.

Configuring Point-to-Multipoint Soft PVC Connections

This section describes configuring point-to-multipoint soft permanent virtual channel (PVC)
connections which provide the following features:
•
•
•
Point-to-Multipoint Soft-PVP connections are not supported.
Note
Route Optimization is not supported for the Point-to-Multipoint Soft PVCs.
Note
OL-7396-01
Connection to multiple hosts or ATM switch routers that support point-to-multipoint Soft PVC
connections.
Creation of point-to-multipoint PVC connections without the complexity of managing large
configurations as described in
Provide reroute or retry capabilities when a failure occurs in the network
Configuring Point-to-Multipoint Soft PVC Connections
Configuring Virtual Channel
ATM Switch Router Software Configuration Guide
Connections.
7-63