Configuring Atm Accounting - Cisco Catalyst 8540 MSR Configuration Manual

Configuring ATM Accounting, RMON, and SNMP
This chapter describes the ATM accounting, Remote Monitoring (RMON), and SNMP features used
with the ATM switch router.
This chapter provides advanced configuration instructions for the Catalyst 8540 MSR,
Note
Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. For complete descriptions of the
commands mentioned in this chapter, refer to the ATM Switch Router Command Reference publication.
This chapter includes the following sections:
•
•
•
Note The ATM accounting and ATM RMON features both require a minimum of 32 MB of dynamic random
access memory (DRAM) installed on the multiservice route processor. If you want to run both ATM
accounting and ATM RMON features together, you must have 64 MB of DRAM.

Configuring ATM Accounting

The following sections describe the process used to enable and configure the ATM accounting feature
on the ATM switch router:
•
•
•
•
•
•
•
•
•
OL-7396-01
Configuring ATM Accounting, page 15-1
Configuring ATM RMON, page 15-14
Configuring SNMP, page 15-20
ATM Accounting Overview, page 15-2
Configuring Global ATM Accounting, page 15-3
Enabling ATM Accounting on an Interface, page 15-4
Configuring the ATM Accounting Selection Table, page 15-5
Configuring ATM Accounting Files, page 15-7
Controlling ATM Accounting Data Collection, page 15-9
Configuring ATM Accounting SNMP Traps, page 15-10
Using TFTP to Copy the ATM Accounting File, page 15-12
Configuring Remote Logging of ATM Accounting Records, page 15-13
C H A P T E R
ATM Switch Router Software Configuration Guide
15
15-1