Chapter 12 Using Acces Control; Displaying The Template Alias Configuration; Configuring Atm Filter Sets - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 12 Using Access Control

Displaying the Template Alias Configuration

To display template alias configuration, use the following privileged EXEC command:
Command
more system:running-config
Example
The following example shows the template aliases configured in the previous examples using the more
system:running-config privileged EXEC command:
Switch# more system:running-config
Building configuration...
Current configuration:
!
version XX.X
no service pad
service udp-small-servers
service tcp-small-servers
!
hostname Switch
!
!
username dtate
ip rcmd remote-username dplatz
atm template-alias training 47.1328...
atm template-alias bit_set 47.9f9(1*0*).88ab...
atm template-alias byte_wise 47.9*f8.33...
!
<information deleted>

Configuring ATM Filter Sets

To create an ATM address filter or time-of-day filter, use the following command in global configuration
mode:
Command
atm filter-set name [index number] [permit |
deny] {template | time-of-day {anytime |
start-time end-time}}
Examples
The following example creates a filter named filter_1 that permits access to the specific ATM address
47.0000.8100.1234.0003.c386.b301.0003.c386.b301.00:
Switch(config)# atm filter-set filter_1 permit
47.0000.8100.1234.0003.c386.b301.0003.c386.b301.00
The following example creates a filter named filter_2 that denies access to the specific ATM address
47.000.8100.5678.0003.c386.b301.0003.c386.b301.00, but allows access to all other ATM addresses:
OL-7396-01
Purpose
Displays the current configuration.
Purpose
Configures a global ATM address filter set.
ATM Switch Router Software Configuration Guide
Configuring ATM Filter Sets
12-3