Cisco Catalyst 8540 MSR Configuration Manual page 694

Configuring IMA Group Functions
Switch(config-if)# ima-group 0
Switch(config-if)# no shut
Switch(config-if)# exit
Switch(config)# interface atm 0/0/ima0
Switch(config-if)# no shut
Switch(config-if)# end
Switch# show ima interface atm 0/0/ima0
ATM0/0/ima0 is up
IMA Group Current Configuration:
IMA Link Information:
Link
-----
ATM0/0/2
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface atm 0/0/ima0
Switch(config-if)# end
Switch(config)# no interface atm 0/0/ima0
Switch(config)# exit
Switch# show ima interface atm 0/0/ima0
% Invalid input detected at '^' marker.
Switch#
ATM Switch Router Software Configuration Guide
21-12
Group Index = 5
State: NearEnd = operational, FarEnd = operational
FailureStatus = noFailure
MinNumTxLinks = 1 MinNumRxLinks = 1
DiffDelayMax = 25 FrameLength
NeTxClkMode = common(ctc)
TestLink = 2
TestProcStatus = disabled
Physical Status
---------------
up
^
Chapter 21
= 128
CTC_Reference_Link = ATM0/0/2
Testpattern = Not Specified
GTSM change timestamp = 000210165420
NearEnd Rx Status
-----------------
active
End with CNTL/Z.
Configuring IMA Port Adapter Interfaces
Test Status
---------------
disabled
OL-7396-01