Lane Bridging Between Atm And Ethernet - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 25 Configuring ATM Router Module Interfaces
Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR)

LANE Bridging Between ATM and Ethernet

The following example show how to configure LANE bridging between ATM and Ethernet using the
ATM router module. Figure 25-5 shows an example of a network for LANE bridging between ATM and
Ethernet.
Figure 25-5 Example Network for LANE Bridging Between ATM and Ethernet
Catalyst 8540 MSR
Router 1 Router 2
GE 9/0/0
ATM 2/0 GE 9/0/0
ATM router module
Interface ATM 2/0/0
Router 1 ATM Interface
Router1# configure terminal
Router1(config)# interface atm 2/0
Router1(config-if)# atm pvc 1 0 5 qsaal
Router1(config-if)# atm pvc 2 0 16 ilmi
Router1(config-if)# lane client ethernet happy
Router1(config-if)# bridge-group 1
Router1(config-if)# end
Router1#
Router 1 Bridge Interface
Router1# configure terminal
Router1(config)# interface BVI1
Router1(config-if)# ip address 130.2.3.1 255.255.255.0
Router1(config-if)# exit
Router1(config)# bridge 1 protocol ieee
Router1(config)# bridge 1 route ip
Router1(config)# bridge irb
Router1(config)# end
Router1#
ATM Switch Router ATM Router Module Interface
Switch# configure terminal
Switch(config)# interface atm 2/0/0.1 multipoint
Switch(config-if)# lane client ethernet happy
Switch(config-if)# bridge-group 1
Switch(config-if)# exit
Switch(config)# bridge 1 protocol ieee
Switch(config)# end
Switch#
ATM Switch Router Ethernet Interface
Switch# configure terminal
Switch(config)# interface gigabitethernet9/0/0
Switch(config-if)# bridge-group 1
Switch(config-if)# end
Switch#
ATM Switch Router Software Configuration Guide
25-14
OL-7396-01