Configuring Route Policies For Rip: Example; Configuring Passive Interfaces And Explicit Neighbors For Rip: Example - Cisco ASR 9000 Series Configuration Manual

Implementing RIP

Configuring Route Policies for RIP: Example

The following example shows how to configure inbound and outbound route policies that are used to control
which route updates are received by a RIP interface or sent out from a RIP interface.
prefix-set pf1
end-set
!
prefix-set pf2
end-set
!
route-policy policy_in
end-policy
!
route-policy pass-all
end-policy
!
route-policy infil
end-policy
!
router rip
interface GigabitEthernet0/6/0/0
!
interface GigabitEthernet0/6/0/2
!
route-policy infil in
route-policy pass-all out

Configuring Passive Interfaces and Explicit Neighbors for RIP: Example

The following example shows how to configure passive interfaces and explicit neighbors. When an interface
is passive, it only accepts routing updates. In other words, no updates are sent out of an interface except to
neighbors configured explicitly.
router rip
interface GigabitEthernet0/6/0/0
!
interface GigabitEthernet0/6/0/2
!
neighbor 172.17.0.1
neighbor 172.18.0.5
!
OL-30423-03
10.1.0.0/24
150.10.1.0/24
if destination in pf1 then
pass
endif
pass
if destination in pf2 then
add rip-metric 2
pass
endif
route-policy policy_in in
passive-interface
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
Configuring Route Policies for RIP: Example
461