Deleting Vccs From An Interface - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Virtual Channel Connections
The following example shows the Switch B PVC configuration on ATM interface 3/0/1, VPI = 0,
VCI = 50, with the switch processor feature card installed:
Switch-B# show atm vc interface atm 3/0/1 0 50
Interface: ATM3/0/1, Type: oc3suni
VPI = 0
Status: UP
Time-since-last-status-change: 4d02h
Connection-type: PVC
Cast-type: point-to-point
Packet-discard-option: disabled
Usage-Parameter-Control (UPC): pass
Wrr weight: 32
Number of OAM-configured connections: 0
OAM-configuration: disabled
OAM-states:
Cross-connect-interface: ATM3/0/2, Type: oc3suni
Cross-connect-VPI = 2
Cross-connect-VCI = 100
Cross-connect-UPC: pass
Cross-connect OAM-configuration: disabled
Cross-connect OAM-state:
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx Clp0 q full drops:0, Rx Clp1 qthresh drops:0
Rx connection-traffic-table-index: 1
Rx service-category: UBR (Unspecified Bit Rate)
Rx pcr-clp01: 7113539
Rx scr-clp01: none
Rx mcr-clp01: none
Rx
Rx
Tx connection-traffic-table-index: 1
Tx service-category: UBR (Unspecified Bit Rate)
Tx pcr-clp01: 7113539
Tx scr-clp01: none
Tx mcr-clp01: none
Tx
Tx

Deleting VCCs from an Interface

This section describes how to delete a VCC configured on an interface. To delete a VCC, perform the
following steps, beginning in global configuration mode:
Command
Step 1
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Step 2 Switch(config-if)# no atm pvc vpi vci
ATM Switch Router Software Configuration Guide
7-6
VCI = 50
Not-applicable
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
cdvt: 1024 (from default for interface)
mbs: none
cdvt: none
mbs: none
Chapter 7 Configuring Virtual Connections
Purpose
Selects the interface to be configured.
Deletes the PVC.
OL-7396-01