Displaying The Tvc Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 16 Configuring Tag Switching and MPLS
Command
Step 1
Switch(config)# interface atm
card/subcard/port[.vpt#]
Switch(config-if)#
Step 2 Switch(config-if)#
wrr-weight
or
Switch(config-if)#
wrr-weight
Example
In the following example, ATM interface 0/0/3 is configured with service class 1 and a WRR weight
of 3:
Switch(config)# interface atm 0/0/3
Switch(config-if)# atm service-class 1 wrr-weight 3

Displaying the TVC Configuration

To display the TVC configuration, perform the following task in EXEC mode:
Command
show atm vc interface atm
card/subcard/port [vpi vci]
The following example shows the service category of the TVC:
Switch# show atm vc interface atm 0/0/3 1 35
Interface: ATM0/0/3, Type: oc3suni
VPI = 1
Status: UP
Time-since-last-status-change: 1d00h
Connection-type: TVC(I)
Cast-type: multipoint-to-point-input
Packet-discard-option: enabled
Usage-Parameter-Control (UPC): pass
Wrr weight: 2
Number of OAM-configured connections: 0
OAM-configuration: disabled
OAM-states:
Cross-connect-interface: ATM0/1/3.10, Type: oc3suni
Cross-connect-VPI = 10
Cross-connect-VCI = 34
Cross-connect-UPC: pass
Cross-connect OAM-configuration: disabled
Cross-connect OAM-state:
Threshold Group: 7, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx pkts:0, Rx pkt drops:0
OL-7396-01
atm service-class
weight
atm service-class
weight
VCI = 35
Not-applicable
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
Purpose
Specifies an ATM interface and enters interface
configuration mode.
{ | | | } Enters the service class and relative weight for a
1 6 7 8
physical interface.
or
{ | | | } Enters the service class and relative weight for a
1 2 3 4
hierarchical interface.
Purpose
Displays the ATM layer connection
information about the virtual connection.
ATM Switch Router Software Configuration Guide
Configuring Tag Switching CoS
16-15