Configuring An E.164 Address Static Route; Displaying The E.164 Static Route Configuration; Configuring An Atm E.164 Address On An Interface - Cisco Catalyst 8540 MSR Configuration Manual

Configuring E.164 Addresses

Configuring an E.164 Address Static Route

To configure an E.164 address static route, use the following command in global configuration mode:
Command
atm route address-prefix atm card/subcard/port
[e164-address address-string [number-type
{international | local | national | subscriber}]]
[internal] [scope org-scope]
Example
The following example uses the atm route command to configure a static route using the 13-byte switch
prefix 47.00918100000000410B0A1081 to ATM interface 0/0/0 with the E.164 address 1234567:
Switch(config)# atm route 47.00918100000000410B0A1081 atm 0/0/0 e164-address 7654321
To complete the E.164 address static route configuration, proceed to the
Address on an Interface" section on page

Displaying the E.164 Static Route Configuration

To display the E.164 address configuration, use the following privileged EXEC command:
Command
show atm route
Example
The following example displays the E.164 address configuration using the show atm route privileged
EXEC command:
Switch# show atm route
Codes: P - installing Protocol (S - Static, P - PNNI, R - Routing control),
P T Node/Port
~ ~~ ~~~~~~~~~~~~~~~~ ~~ ~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
S E 1
P SI 1
R I 1
R I 1
P SI 1
S E 1
R I 1
R I 1

Configuring an ATM E.164 Address on an Interface

One E.164 address can be configured per ATM port. Signalling uses E.164 addresses in the called and
calling party IEs, and uses AESA addresses in the called and calling party subaddress IEs.
ATM Switch Router Software Configuration Guide
17-6
T - Type (I - Internal prefix, E - Exterior prefix, SE -
Summary Exterior prefix, SI - Summary Internal prefix,
ZE - Suppress Summary Exterior, ZI - Suppress Summary Internal)
St Lev Prefix
ATM0/1/0 DN 0 47.0091.8100.0000.0001/72
0 UP 0 47.0091.8100.0000.0002.eb1f.fe00/104
ATM2/0/0 UP 0 47.0091.8100.0000.0002.eb1f.fe00.0002.eb1f.fe00/152
ATM2/0/0 UP 0 47.0091.8100.0000.0002.eb1f.fe00.4000.0c/128
0 UP 0 47.0091.8100.0000.0040.0b0a.2b81/104
ATM0/0/0 DN 0 47.0091.8100.0000.0040.0b0a.2b81/104
(E164 Address 1234567)
ATM2/0/0 UP 0 47.0091.8100.0000.0040.0b0a.2b81.0040.0b0a.2b81/152
ATM2/0/0 UP 0 47.0091.8100.0000.0040.0b0a.2b81.4000.0c/128
Chapter 17
Purpose
At the configure prompt, configures the static
route prefix with the E.164 address.
17-6.
Purpose
Displays the static route E.164 address
configuration.
Configuring Signalling Features
"Configuring an ATM E.164
OL-7396-01