Configuring The Retry Interval For Point-To-Multipoint Soft-Pvc Parties; Deleting A Point-To-Multipoint Soft Pvc - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Point-to-Multipoint Soft PVC Connections
The word "Inactive" appears under the State field for party leaf-reference 20 disable in the previous
section but, the second party leaf-reference 30, that was not disabled, has the word "Active" under the
State field.

Configuring the Retry Interval for Point-to-Multipoint Soft-PVC Parties

To configure the first and maximum retry intervals for each party of a point-to-multipoint Soft PVC
connection, perform the following steps, beginning in ATM Soft PVC party configuration mode:
Command
Switch(atmsoft-p2mp-party)# retry-interval
first {100-3600000} maximum
{100-4294967295}
Examples
The following example configures the first and maximum retry intervals for each party of a
point-to-multipoint soft PVC connection configured on an ATM interface:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface atm 0/0/1
Switch(config-if)# atm soft-vc 50 100 p2mp
Switch(atmsoft-p2mp)# party leaf-reference 2
Switch(atmsoft-p2mp-party)# retry-interval first 200 maximum 300

Deleting a Point-to-Multipoint Soft PVC

This section describes how to delete a point-to-multipoint soft PVC configured on an interface.
To remove the whole point-to-multipoint soft PVC connection, perform the following steps, beginning
in global configuration mode:
Command
Switch(config)# interface atm
card/subcard/port
Switch(config-if)#
Switch(config-if)# no atm soft-vc vpi vci
Example
The following example shows how to remove the whole point-to-multipoint soft PVC connection
configured on ATM interface 0/0/1, VPI = 50, VCI = 100:
Source# config terminal
Enter configuration commands, one per line.
Source(config)# interface atm 0/0/1
Source(config-if)# no atm soft-vc 50 100
ATM Switch Router Software Configuration Guide
7-72
Chapter 7
Purpose
Configures the first and maximum retry
intervals in milliseconds on a
point-to-multipoint soft PVC connection.
End with CNTL/Z.
Purpose
Selects the interface to be configured.
Deletes all of the point-to-multipoint
soft PVCs.
End with CNTL/Z.
Configuring Virtual Connections
OL-7396-01