Displaying The Hierarchical Vp Tunnel Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 7 Configuring Virtual Connections
To configure a hierarchical VP tunnel, perform the following steps, beginning in global configuration
mode:
Command
Step 1
Switch(config)# atm
connection-traffic-table-row [index row-index]
cbr pcr rate
Step 2
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Step 3 Switch(config-if)# atm pvp vpi hierarchical
rx-cttr index tx-cttr index
Step 4 Switch(config-if)# exit
Switch(config)#
Step 5
Switch(config)# interface atm
card/subcard/port.vpt#
Switch(config-subif)#
The rx-cttr and tx-cttr row indexes must be configured before they are used.
Note
Example
The following example shows how to configure a hierarchical VP tunnel with a PVP of 99 as
ATM interface 0/0/0.99
Switch(config)# interface atm 0/0/0
Switch(config-if)# atm pvp 99 hierarchical rx-cttr 100 tx-cttr 100
Switch(config-if)# exit
Switch(config-if)# interface atm 0/0/0.99
Switch(config-subif)#

Displaying the Hierarchical VP Tunnel Configuration

To display the hierarchical VP tunnel interface configuration, use the following EXEC command:
Command
show atm interface atm
card/subcard/port.vpt#
OL-7396-01
Purpose
Configures the connection-traffic-table row for
the desired PVP CBR cell rate.
Selects the physical interface to be configured.
Configures an interface PVP leg.
Exits interface configuration mode.
Creates a hierarchical VP tunnel using a
VP tunnel number that matches the PVP leg VPI.
Purpose
Shows the ATM VP interface configuration.
ATM Switch Router Software Configuration Guide
Configuring VP Tunnels
7-85