Displaying The Autoconfiguration - Cisco Catalyst 8540 MSR Configuration Manual

Disabling Autoconfiguration
To disable autoconfiguration on an interface, perform the following steps, beginning in global
configuration mode:
Command
Step 1
Switch(config)# interface atm
card/subcard/port[.vpt#]
Switch(config-if)#
Step 2 Switch(config-if)# no atm auto-configuration
Example
The following example shows how to disable autoconfiguration on interface ATM 1/0/0:
Switch(config)# interface atm 1/0/0
Switch(config-if)# no atm auto-configuration
Switch(config-if)#
%ATM-6-ILMINOAUTOCFG: ILMI(ATM1/0/0): Auto-configuration is disabled, current interface
parameters will be used at next interface restart.

Displaying the Autoconfiguration

To confirm that autoconfiguration is disabled for the interface, use the following EXEC command:
Command
show atm interface atm card/subcard/port
Example
The following example shows the autoconfiguration status of ATM interface 1/0/0 as disabled:
Switch# show atm interface atm 1/0/0
Interface:
IF Status:
Auto-config:
IF-Side:
Uni-type:
Max-VPI-bits:
Max-VP:
ConfMaxSvpcVpi: 255
ConfMaxSvccVpi: 255
ConfMinSvccVci: 35
Svc Upc Intent: pass
ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.8000.00
Configured virtual links:
PVCLs SoftVCLs
Logical ports(VP-tunnels): 0
Input cells:
5 minute input rate:
5 minute output rate:
Input AAL5 pkts: 171880, Output AAL5 pkts: 175134, AAL5 crc errors: 0
ATM Switch Router Software Configuration Guide
6-2
ATM1/0/0
UP
disabled
Network
not applicable
8
255
SVCLs TVCLs
4 0 0
263250
Purpose
Selects the interface to be configured.
Disables autoconfiguration on the interface.
Purpose
Shows the ATM interface configuration.
Port-type: oc3suni
Admin Status: up
AutoCfgState: not applicable
IF-type: NNI
Uni-version: not applicable
Max-VCI-bits: 14
Max-VC: 16383
CurrMaxSvpcVpi: 255
CurrMaxSvccVpi: 255
CurrMinSvccVci: 35
Signalling: Enabled
PVPLs SoftVPLs SVPLs Total-Cfgd Inst-Conns
0 1 0
Output cells: 269783
0 bits/sec, 0 cells/sec
0 bits/sec, 0 cells/sec
Chapter 6 Configuring ATM Network Interfaces
0 5 3
OL-7396-01