Configuring Atm Accounting Snmp Traps; Configuring Atm Accounting Trap Generation; Displaying Atm Accounting Trap Threshold Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Configuring ATM Accounting

Configuring ATM Accounting SNMP Traps

You can configure SNMP traps to be generated when the ATM accounting file reaches a specified
threshold. You can use these traps to alert you when a file is full and needs to be downloaded.

Configuring ATM Accounting Trap Generation

To configure ATM accounting SNMP traps, use the following command in global configuration mode:
Command
atm accounting trap threshold
percent-value
Example
The following example shows how to configure ATM accounting SNMP traps to be sent when the file
size reaches 85 percent full:
Switch(config)# atm accounting trap threshold 85

Displaying ATM Accounting Trap Threshold Configuration

To display the ATM accounting trap threshold configuration, use the following EXEC command:
Command
show atm accounting
Example
The following example shows the ATM accounting trap threshold configuration using the
show atm accounting command:
Switch# show atm accounting
ATM Accounting Info:
Trap Threshold - 90 percent (4500000 bytes)
Interfaces:
File Entry 1: Name acctng_file1
selection Entry -
Active selection -
<information deleted>
ATM Switch Router Software Configuration Guide
15-10
AdminStatus - UP;
Descr: atm accounting data
Min-age (seconds): 3600
Failed_attempt : C0
Sizes: Active 69 bytes (#records 0); Ready 73 bytes (#records 0)
Selection entry 1, subtree - 1.3.6.1.4.1.9.10.18.1.1
Selection entry 1, list - FF.FE.BF.FC
Selection entry 1, connType - F0.00
Selection entry 1, subtree - 1.3.6.1.4.1.9.10.18.1.1
Selection entry 1, list - FF.FE.BF.FC
Selection entry 1, connType - F0.00
Chapter 15 Configuring ATM Accounting, RMON, and SNMP
Purpose
Configures the ATM accounting file threshold
to generate an SNMP trap when it reaches a
percentage of the maximum size.
Purpose
Displays the ATM accounting trap
configuration.
OperStatus : UP
OL-7396-01