Displaying The Ima Group Test Pattern Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Configuring IMA Group Parameters
Command
Step 2 Switch(config-if)# ima test [link link-value]
[pattern pattern-value]
Step 3 Switch(config-if)# no ima test
Examples
The following example shows how to configure the test pattern 8 to transmit over link 3 of
IMA group 0/0/ima1:
SwitchA(config)# interface atm 0/0/ima1
SwitchA(config-if)# ima test link 3 pattern 8
The following example shows how to stop the test on IMA group 0/0/ima1:
SwitchA(config)# interface atm 0/0/ima1
SwitchA(config-if)# no ima test

Displaying the IMA Group Test Pattern Configuration

To display the IMA group test pattern configuration, use the following EXEC command:
Command
show ima interface [atm card/subcard/imagroup
[detailed]]
Example
The following example shows the IMA group test pattern configuration:
SwitchA# show ima interface
ATM0/0/ima1 is up
IMA Group Current Configuration:
IMA Link Information:
Link
-----
ATM0/0/2
ATM0/0/3
ATM Switch Router Software Configuration Guide
21-18
Group Index = 4
State: NearEnd = operational, FarEnd = operational
FailureStatus = noFailure
MinNumTxLinks = 1 MinNumRxLinks = 1
DiffDelayMax = 25 FrameLength
NeTxClkMode = common(ctc)
TestLink = 3 TestPattern
TestProcStatus = operating
Physical Status
---------------
up
up
Chapter 21
Purpose
Specifies the specific link and pattern or test
pattern only for the IMA group.
Stops the test on the IMA group.
Purpose
Displays IMA group interface configuration
and status.
= 128
CTC_Reference_Link = ATM0/0/3
= 8
GTSM change timestamp = 990427143950
NearEnd Rx Status
-----------------
active
active
Configuring IMA Port Adapter Interfaces
Test Status
---------------
operating
operating
OL-7396-01