Displaying The Redundant Soft Vc Destination Address Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 7 Configuring Virtual Connections

Displaying the Redundant Soft VC Destination Address Configuration

To show the redundant soft VC destination address configuration, use the following EXEC command:
Command
Switch# show atm soft redundancy group
[group-name]
Switch# show atm addresses
The following example shows all the ATM soft VC redundancy groups configured.
Switch# show atm soft redundancy group
Group Name: group1
Nsap Address: 47.0091.8100.0000.00a0.f209.b601.3000.0c88.1080.00
Operating Mode: Active/Standby
Configured Active Interface: ATM0/0/1 (Status: Down)
Configured Standby Interface:
Group Name: group2
Nsap Address: 47.0091.8100.0000.00a0.f209.b601.3333.3333.3333.00
Operating Mode: Active/Standby
Configured Active Interface: ATM0/0/1 (Status: Down)
Configured Standby Interface:
Group Name: group3
Nsap Address: 11.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00
Operating Mode: Load Balance
1:
2:
Group Name: group4
Nsap Address: 12.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00
Operating Mode: Active/Standby
Configured Active Interface:
Configured Standby Interface:
Group Name: group5
Nsap Address: 13.2233.4455.6677.8c11.1111.1111.4000.0c80.0000.00
Operating Mode: Load Balance
1:
2:
Switch#
OL-7396-01
Interface Name Status
ATM0/0/1 Up
ATM0/0/3 Up
Interface Name Status
ATM0/1/ima0 Up
ATM0/0/0 Up
Configuring Backup Addresses for Soft PVC and Soft PVP Connections
Purpose
Displays the ATM soft redundancy group
configuration.
Displays the ATM NSAP address of the
redundant soft PVC destination.
Number of VCs Number of VPs
1500 0
1500 0
Number of VCs Number of VPs
3 0
3 0
ATM Switch Router Software Configuration Guide
7-61