Configuring Soft Pvp Connections - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Soft PVP Connections

The following example modifies the packet discard option to Off for an existing soft PVC.
Switch(config)# interface atm 0/0/3
Switch(config-if)# atm soft-vc 8 990 pd off
The following example specifies different receive and transmit CTTR indexes and PD option for an
existing soft PVC.
Switch(config)# interface atm 0/0/3
Switch(config-if)# atm soft-vc 8 990 rx-cttr 444 tx-cttr 444 pd off
The following example displays the receive and transmit CTTR indexes and packet-discard-option for
the soft PVC configured on ATM interface 0/0/3.
Switch# show atm connection-traffic-table 444
Row
444
The following example specifies the CTTR index and specifies the PD use the PD option specified in the
CTTR index.
Switch(config)# interface atm 0/0/3
Switch(config-if)# atm soft-vc 8 990 rx-cttr 444 tx-cttr 444 pd use-cttr
Configuring Soft PVP Connections
This section describes configuring soft permanent virtual path (PVP) connections, which provide the
following features:
•
•
•
Figure 7-7
Figure 7-7
User A
ATM Switch Router Software Configuration Guide
7-26
Service-category
cbr
Connection to another host or ATM switch router that does supports signalling
Configuration of PVPs without the manual configuration steps described in the
Channel Connections" section on page
Configuration of PVPs with the reroute or retry capabilities when a failure occurs within the network
is an illustration of the soft PVP connections used in the examples in this section.
Soft PVP Connection Example
Switch B
IF# = 0/0/2
VPI = 75
Address = 47.0091.8100.0000.0040.0b0a.2a81.4000.0c80.9010.00
pcr scr/mcr
256
2.
Switch C
ATM network
Chapter 7 Configuring Virtual Connections
mbs cdvt pd
none off
"Configuring Virtual
User D
IF# = 1/1/1
VPI = 75
OL-7396-01