Loading Functional Images (Catalyst 8510 Msr And Lightstream 1010) - Cisco Catalyst 8540 MSR Configuration Manual

Maintaining Functional Images (Catalyst 8510 MSR and LightStream 1010)

Loading Functional Images (Catalyst 8510 MSR and LightStream 1010)

You load a functional image in two steps:
Copy the image to a Flash memory device (bootflash, slot0, or slot1). For instructions on copying files
Step 1
to a Flash memory device, refer to the Configuration Fundamentals Configuration Guide.
Step 2 Load the image from the Flash memory device to the hardware controller.
The command for loading functional images on the ATM switch router differs from that described in the
Note
Cisco IOS documentation.
To download a functional image from a Flash memory device to a hardware controller, use the following
command in privileged EXEC mode:
Command
reprogram device:filename {slot [subcard] |
rommon}
The reprogram command checks the compatibility of the image for the selected card type before
downloading the functional image.
Do not interrupt the download procedure. Wait until it has finished before attempting any commands on
Caution
the switch.
Example
The following example demonstrates loading the functional image abr_tmp.exo from the Flash PC card
in slot 0 to the controller in slot 0, subcard 1:
Switch# reprogram slot0:abr_tmp.exo 0 1
ATM Switch Router Software Configuration Guide
26-8
Chapter 26 Managing Configuration Files, System Images, and Functional Images
Purpose
Loads the functional image with the specified
filename to a device.
OL-7396-01