Mapping A Protocol Address To A Pvc Using Static Map Lists; Configuring A Pvc-Based Map List - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 13 Configuring IP over ATM
Example
The following example displays the map-list configuration of the static map and IP-over-ATM
interfaces:
Switch# show atm map
Map list yyy : PERMANENT
ip 1.1.1.2 maps to VPI=0 VCI=200
Map list zzz : PERMANENT
Map list a : PERMANENT
Map list 1 : PERMANENT
Map list ATM2/0/0_ATM_ARP : DYNAMIC
arp maps to NSAP 47.009181005670000000001122.00410B0A1081.40
ip 10.0.0.5 maps to NSAP 47.009181005670000000001122.00410B0A1081.40

Mapping a Protocol Address to a PVC Using Static Map Lists

The ATM interface supports a static mapping scheme that identifies the ATM address of remote hosts or
ATM switch routers. This IP address is specified as a permanent virtual channel (PVC) or as a network
service access point (NSAP) address for switch virtual channel (SVC) operation.
The following sections describe configuring both PVC-based and SVC-based map lists on the ATM
switch router. For a more detailed discussion of static map lists, refer to the Guide to ATM Technology.
Configurations for both PVC and SVC map lists are described in the following sections:
•
•

Configuring a PVC-Based Map List

This section describes how to map a PVC to an address, which is a required task if you are configuring
a PVC.
You enter mapping commands as groups. You first create a map list and then associate it with an
interface. Perform the following steps, beginning in global configuration mode:
Command
Step 1
Switch(config-if)# interface atm
card/subcard/port[.subinterface#]
Step 2
Switch(config-if)# ip address ip-address mask
Step 3
Switch(config-if)# map-group name
OL-7396-01
, connection up, VPI=0 VCI=85, ATM2/0/0
, broadcast, ATM2/0/0
Configuring a PVC-Based Map List, page 13-7
Configuring an SVC-Based Map List, page 13-9
Mapping a Protocol Address to a PVC Using Static Map Lists
Purpose
Specifies an ATM interface and enters interface
configuration mode.
Enters the IP address and subnet mask associated
with this interface.
Enters the map group name associated with this
PVC.
ATM Switch Router Software Configuration Guide
13-7