Configuring Oam Functions; Configuring Oam For The Entire Switch (Catalyst 8540 Msr); Configuring Oam For The Entire Switch (Catalyst 8510 Msr And Lightstream 1010) - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 8 Configuring Operation, Administration, and Maintenance

Configuring OAM Functions

This section describes OAM commands in EXEC, global, and interface configuration mode.

Configuring OAM for the Entire Switch (Catalyst 8540 MSR)

To enable OAM operations for the Catalyst 8540 MSR, use the global configuration command, as shown
in the following table:
Command
atm oam [ais] [end-loopback]
[max-limit number] [rdi] [seg-loopback]
The number of maximum OAM configured connections allowed ranges from 1 to 3200; the default
Note
is 3200.
Examples
The following example shows how to enable AIS and segment loopback for the entire switch:
Switch(config)# atm oam ais seg-loopback
% OAM: Switch level seg loopback is enabled
% OAM: Switch level ais is enabled
The following example shows how to configure the ATM OAM connection maximum to 1600:
Switch(config)# atm oam max-limit 1600
Configuring OAM for the Entire Switch (Catalyst 8510 MSR and
LightStream 1010)
To enable OAM operations for the entire Catalyst 8510 MSR and LightStream 1010 ATM switch router,
use the global configuration command, as shown in the following table:
Command
atm oam [ais] [end-loopback]
[intercept end-to-end] [max-limit number]
[rdi] [seg-loopback]
The number of maximum OAM configured connections allowed ranges from 1 to 3200; the default
Note
is 3200.
Examples
The following example shows how to enable AIS and segment loopback for the entire switch:
OL-7396-01
Purpose
Enables or disables OAM operations for the
entire switch.
Purpose
Enables or disables OAM operations for the
entire switch.
ATM Switch Router Software Configuration Guide
Configuring OAM Functions
8-3